Technical Data - OHAUS C51-Serie Bedienungsanleitung

3. OPERATION
Button
Primary Function
(Short Press)
If Indicator is On, sets
zero.
Secondary
Function
Turns the Indicator
(Long Press) on or off.
Menu Function
(Short Press)
Accepts the current
setting on the display.
4. MAINTENANCE
4.1 Cleaning
W ARNING: Electric Shock Hazard. Disconnect the equipment from the power supply before cleaning.
Make sure that no liquid enters the interior of the instrument.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.
The exterior surfaces of the instrument may be cleaned with a cloth dampened with water and a mild detergent.
4.2 Troubleshooting
For technical issues contact an Authorized Ohaus Service Agent. Please visit our website www.ohaus.com to locate the
Ohaus office nearest you.

5. TECHNICAL DATA

The technical data is valid under the following conditions:
- Indoor use only
- Altitude: Up to 2000 m
- Operating temperature range: -10 ° C to +40 ° C
- Relative humidity: 10% to 85% at 31° C, decreasing linearly to 50% at 40° C, non-condensing
- Power: AC power adaptor input 100-240V 50/60 Hz and output 12V DC, or 6V DC lead acid rechargeable battery
- Mains supply voltage fluctuations: up to ± 10% of the nominal voltage
- Installation category II
- Pollution degree: 2
ON/ZERO
Sends the current
value to the COM
port if AUTOPRINT is
set to Off.
Off
Changes the
weighing Unit.
Yes
Advances to the next
menu or menu item.
Rejects the current
setting on the display
and advances to the
next available setting.
Increments the value.
PRINT FUNCTION
Initiates an
application mode.
Units
Allows changing the
application mode.
Press and hold
allows scrolling
through modes.
No
Moves Back to
previous menu item.
Decrements the
value.
TARE
Performs a tare
operation.
Mode Menu
Enter the User menu.
Back Exit
Exits the User menu.
Aborts the calibration
in progress.
EN-3