Waeco ASC 6100G Bedienungsanleitung Seite 23

2. In the basic menu use the cursor keys
Short selection
Free selection
Other selections
ENTER-OK
3. Press ENTER
4. Enter the vehicle data and press
13.8.1 Recovery phase
1. Enter the preferred settings and press
Rec/Recycling
phase?
ENTER-OK STOP-EXIT
2. If Rec/Recycling phase has been selected, enter the preferred waiting time for the pressure increase (stan-
dard is 1 min.) in the following menu and press
process on page 23.
Pressure increase
Test time
ENTER-OK STOP-EXIT
Note The waiting time ensures that any residual refrigerant vaporises and can then be extracted. The
vaporising residual refrigerant triggers an increase in pressure.
13.8.2 Vacuum process
1. Enter the preferred settings and press
Vacuum phase
ENTER-OK STOP-EXIT
2. If Vacuum phase has been selected, enter the preferred vacuum time (standard is 20 min), otherwise continue
with chapter Filling process
3. Use the cursor key
4. Press ENTER to confirm both settings.
Vacuum time
Vacuum test time
ENTER-OK STOP-EXIT
The air conditioning system is drained completely by the vacuum pump. This is used to remove any remaining
carrier gases or moisture and to prepare the air conditioning system for the filling process. Any residual refrig-
erant extracted which is still bonded in the refrigerant oil is collected by the A/C Service unit and recycled.
13.8.3 Filling process
1. Enter the preferred settings and press
Filling phase?
ENTER-OK STOP-EXIT
2. If Filling phase has been selected, enter the required value, otherwise continue with chapter
nections on page 24.
3. Enter the amount of refrigerant oil which was previously drained or which is required.
to confirm.
ENTER
ENTER
min.
ENTER
on page 23.
to enter the vacuum phase time.
min.
min.
ENTER
or to select Free selection.
to confirm.
to confirm.
Yes
No
ENTER to confirm, otherwise continue with chapter
1
to confirm.
Yes
No
20
4
to confirm.
Yes
No
EN
Vacuum
Selecting con-
23