Selecting The Language - Waeco ASC 6100G Bedienungsanleitung

EN
6. Enter the hose length in centimetres.
7. Press ENTER
12.4

Selecting the language

1. Press the cursor keys
2. In the basic menu use the cursor keys
Short selection
Free selection
Other selections
ENTER-OK
3. Press ENTER
4. Use the cursor key
5. Press ENTER
6. Enter the password
7. Use the cursor keys
8. Press ENTER
9. Press STOP .
The language chosen is active and the standby menu is displayed.
12.5 Entering the company data
The company data is printed out with every service log.
1. In the basic menu use the cursor keys
Short selection
Free selection
Other selections
ENTER-OK
2. Press ENTER
3. Use the cursor key
4. Press ENTER
5. Enter the password
The company data is shown in the third line of the display.
You can enter five lines, each with up to 20 characters.
The display shows the number of lines of company data after the message Enter company data (01 to 05).
Use the cursor keys
6. Use the keypad and the cursor keys to enter the data. To switch between upper and lower case, press the
key. To delete a character, briefly press the
key.
7. Press ENTER
8. Press STOP .
The set data is activated.
9. Press STOP
again.
The standby menu is displayed.
12
to confirm.
or .
to confirm.
to select Service.
to confirm.
.
5264
or to select the preferred language.
to confirm.
to confirm.
to select Service.
to confirm.
.
3282
or to select the line of company data you want.
to confirm.
or to select Other selections.
or to select Other selections.
C
key. To delete the current line, press and hold down the
C