Panasonic EY3552 Bedienungsanleitung Seite 10

11) Be careful not to drop Metal Cutter.
12) Never swing Metal Cutter.
13) Never cover the ventilation slots, and keep
them free from dust or other material.
14) Do not clamp Metal Cutter in a vise. Never
cut with Metal Cutter held upside down in a
vise. This is extremely dangerous and can
lead to serious accidents.
15) Never wear knitted gloves.
16) Be sure no one is below when using Metal
Cutter in high locations.
17) Do not touch the blade immediately after
operation. It may be hot and could burn
your skin.
18) Do not touch material after it has been cut.
Cut material may be very hot.
19) Do not use cutting oil.This use of cutting oil
may cause a fire.
20) Do not cut workpieces covered or stained
with gas, oil, solvents, thinners, etc.
Exposure to these materials may damage
the transparent guard.
21) Do not remove the transparent and lower
guards. If the transparent and lower guards
is damaged or missing, return tool to
authorized service center for replacement.
22) Do not start the blade when in contact with
workpiece. Wait for blade to reach full speed
before beginning cut.
Symbol
Symbol
V
n
0
Revolutions or reciprocations
··· / min
per minute
A
Meaning
Volts
Direct current
No load speed
Amperes
- 10 -
III
. SETTING UP
Charging Battery Pack EY9251
Charge the battery pack when the cutting speed
becomes too slow for effective cutting.
If you have two battery packs, you can use one to
continue working while charging the other one.
NOTE:
When you charge the battery pack for the first
time, or after prolonged storage, charge it for
about 24 hours to bring the battery up to full
capacity.
Battery charger (EY0110)
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the plug is
inserted into the AC power supply, but this is
not a problem in terms of safety.
2. Insert the battery pack firmly into the charger.
Battery
pack
3. During charging, the charging lamp will be lit.
When charging is completed, an internal elec-
tronic switch will automatically be triggered to
prevent overcharging.
• Charging will not start if the battery pack
is warm (for example, immediately after
heavy-duty operation).
The orange standby lamp will be lit until the
battery cools down. Charging will then begin
automatically.
4. When charging is completed, the charging
lamp will start flashing quickly in green color.
5. When in any of the conditions that battery
pack is too cool, or the battery pack has not
been used for a long time, the charging lamp
is lit. In this case, charging takes longer to fully
charge the battery pack, than the standard
charging time.
• If a fully charged battery pack is inserted
into the charger again, the charging lamp
lights up. After several minutes, the charg-
ing lamp may flash quickly to indicate the
charging is completed.
2
To AC
outlet
1
Battery
charger