Indicator Light; Restore Factory Settings - imilab C21 Bedienungsanleitung

Indicator Light

Steady blue on: connected/device status is normal
Flashing blue: network error
Flashing orange rapidly: waiting for connection
Flashing orange slowly: system upgrade in progress
Installing a MicroSD Card
Make sure that the power to IMILAB C21 is already disconnected. Adjust the camera lens
upward until the MicroSD slot is revealed, then insert the MicroSD card into the slot (the
side with contact points must be facing down).
Note: Please turn off the IMILAB C21's power supply before inserting or removing the
MicroSD card. Please use a genuine Micro SD card manufactured by a qualified supplier,
with a reading/writing speed of no less than U1/Class 10. (Maximum support capacity
is 64 GB)
RESET
MicroSD

Restore Factory Settings

Press and hold the reset hole with fine needle, then you can hear the "reset succeed"
voice.
Data stored on the MicroSD card is not deleted.
EN-05