Indicator Light; Installing A Microsd Card; Restore Factory Settings - imilab A1 Bedienungsanleitung

Indicator Light

Steady blue on: connected/device status is normal
Flashing blue: network error
Flashing orange rapidly: waiting for connection
Flashing orange slowly: system upgrade in progress

Installing a MicroSD Card

Make sure that the power to IMILAB Home Security Camera A1 is already disconnected.
Adjust the camera lens upward until the MicroSD slot is revealed, then insert the MicroSD
card into the slot (the side with contact points must be facing down).
Note:
Please turn off the IMILAB Home Security Camera A1's power supply before inserting or
removing the MicroSD card. Please use a genuine Micro SD card manufactured by a
qualified supplier, with a reading/writing speed of no less than U1/Class 10. (Maximum
support capacity is 256GB)
MicroSD

Restore Factory Settings

Press and hold the Reset button to restore your device to factory settings.
Data stored on the MicroSD card is not deleted.
EN-05