Safety Instructions; Laser Radiation - CONDTROL XLiner Pento 360 Bedienungsanleitung

Pento 360 / Quattro 360 G / Pento 360 G
EN
CROSS LINE LASER
Congratulations on your purchase of the laser level XLiner Pento 360
/ Quattro 360 G / Pento 360 G CONDTROL. Safety instructions can
be found in the end of this user manual and should be carefully read
before you use the device for the first time.

SAFETY INSTRUCTIONS

Attention! This user manual is an essential part of this product.
The user manual should be read carefully before you use the product
for the first time. If the product is given to someone for temporary
use, be sure to enclose user manual to it.
- Do not misuse the product
- Do not remove warning signs and protect them from abrasion,
because they contain information about safe operation of the
product.
- Do not look into the laser beam or its reflection, with unprotected
eye or through an optical device. Do not point the laser beam at
people or animals without the need. You can dazzle them.
- To protect your eyes close them or look aside.
- Always install the product in such a way, so that laser line is below
or above eye level.
- Do not let unauthorized people enter the zone of product operation.
- Store the product beyond reach of children and unauthorized
people.
- Do not disassemble or repair the product yourself. Entrust product
repair to qualified personnel and use original spare parts only.
- Do not use the product in explosive environment, close to flammable
materials.
4 4

LASER RADIATION!

Do not stareinto beam
Class 2 laser
<1 mW, 635/515 nm
IEC 60825-1: 2007-03
user manual