Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Optionally, you can also use the slider in the center at the bottom to move carefully from left
to right; this allows stepless control.
With the button [Zero] you directly select setpoint zero to stop the system.
•
If the system behaves correctly at this point, you have confirmed correct operation and can
continue to operate the system as desired.
•
When your test is complete, press the [OFF] button (up/left) to turn the unit off; you will hear
the relay click.
Error message
If an error has occurred in the system, it will be indicated in the „Error" menu; the corresponding
„Error" display will also be highlighted in red at the top/left.
NOTE
If you detect a defect, do not operate the drive under any circumstances and contact our
service department.
GRAPH tool
You can get even more detailed information via the [Graph] tab (bottom/left). Here you can display
and save the history.
Here you can control the drive simultaneously via the slider in the start menu.
Put a check mark at „Active" to follow the measurement in real time.
What you can take from the GUI
The GUI helps you to set your drive to maximum efficiency.
Voltage, current, current consumption, running direction and values of the connected sensors (tem-
peratures, speed) give you a picture of the efficiency and function of your drive.
If you change values, compare the output parameters after the change. This way you can optimize
the drive according to your ideas or adapt it to a new environment.
Brushless DC Controller HST-350
Orginal operating manual
Mounting and commissioning
Page 60 of 62
Rev1.3
Werbung
Inhaltsverzeichnis
