Hacker HST-350 Betriebsanleitung Seite 52

Flashing a new Firmware
! Be sure to flash Device 69 first, then Device 35 !
• After you have scanned the device „69", select the current firmware
file in your software package. The firmware is the basic software of
the controller. You will find it in the directory EE-VerXX. There please
select the file starting with the name MU69 and confirm.
• Then press the button [Boot] as shown in the next picture; the button
turns blue and the system acknowledges with the status message
„Boot mode".
• Now press the [Flash] button, this will transfer the software to the controller.
Brushless DC Controller HST-350
Orginal operating manual
Mounting and commissioning
Page 52 of 62
Rev1.3