Hacker HST-350 Betriebsanleitung Seite 50

2
3
• Now establish a connection to the controller by
o first select the adapter (here HerSi adapter)
o now initialize the system (press [Initialize])
o press [Get version] at the bottom left to display the currently installed firmware version
(basic software of the controller).
o now in the field „Received Data" the data log should be visible and permanently updated
o then press [scan motors]; you should then see device 69 in the „devices in normal mode"
window as motor no. 1
• The controller has now successfully connected to the programming interface.
• The controller is now ready for operation and can be flashed or parameterized with new firm-
ware.
Brushless DC Controller HST-350
Orginal operating manual
1
4
Mounting and commissioning
5
Page 50 of 62
Rev1.3