VONROC CS504DC Bersetzung Der Originalbetriebsanleitung Seite 12

EN
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on
the charger (19) will lighten up and show the
charger status.
The charger has 2 LED indicators (19) which indi-
cate the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charg-
er plug from the outlet and remove the battery from
the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Tool assembly (Fig. C, D)
• Attach the shoulder strap (11) to the loop on
the handle (9) using the carabiner (12).
• Release the head locking ring (3) by rotating it
anti-clockwise. Do not completely remove the
ring from the head.
• Fit the chain saw head (1) to the telescopic
handle (9) by inserting the power connector
(10) into the head.
• If the connector (10) is not inserted properly,
there might be no electrical connection and the
tool will not work. Make sure that the power con-
nector is fully inserted into the chain saw head.
The screw (20) on the handle should be covered
by the chain saw head (1) and locking ring (3).
• Secure the chain saw head (1) by rotating the
locking ring (3) clockwise
12
Adjusting the telescopic height (Fig. E-1, E-2)
• Unlock the lever (7) to release the telescopic
handle (9).
• Extend or retract the telescopic handle (9) to
Charger status
the desired length.
No power
• Secure the telescopic handle by locking the
lever (7).
Standby mode:
- No battery
Adjusting the pivoting chain saw head (Fig. F-1,
present, or:
F-2)
- Battery present,
• Press both the button (2) on the side of the
charging has
chain saw head (1).
finished
• Adjust the head to the desired position.
Battery charging in
• Release the button (2) and make sure the head
progress
is locked in place.
4. OPERATION
Before use (Fig. G)
Remove the chain cover (13) and check the oil level
in the reservoir (6). Do not operate the saw with
an empty oil reservoir. Use biodegradable chain
saw oil only. Check if the chain (4) is correctly
tensioned. The chain is correctly tensioned when it
can be raised approx. 2-3mm by hand in the center
of the chain bar (5).
Switching on and off
Always hold the telescopic chain saw with both
hands. Place one hand on the telescopic handle (9)
and one hand on the rear handle near the power
switch. Press and hold the power switch (8) to
operate the machine. When the power switch is
released the machine will automatically stop.
During use
Bring the chain up to speed before contacting the
wood. Do not force the chain saw while cutting.
Keep the machine at a steady speed and let the
chain do the work. Regularly check the oil level in
the reservoir, top up the reservoir before it runs
completely dry.
When sawing off large/long branches, sawing off in
parts is recommended.
Never fasten the belt diagonally across the
shoulder and chest, but place it on one of
the shoulders. This way you can quickly
remove the tool from your body in case of
danger.
WWW.VONROC.COM