VONROC CS504DC Bersetzung Der Originalbetriebsanleitung Seite 11

Model No.
Battery Type
Voltage
Capacity
Recommended charger
Weight
Model No.
Charger input
Charger output
Charging time 2Ah battery
Charging time 4Ah battery
Recommended batteries
Weight
Model No.
Battery Type
Voltage
Capacity
Recommended charger
Weight
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other bat-
teries could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 5.
1. Chain saw head
2. Head adjustment button
3. Head locking ring
4. Saw chain
5. Chain saw bar
WWW.VONROC.COM
6. Oil reservoir cap
CD801AA
7. Handle locking lever
Lithium-Ion
8. Power switch
20V
9. Telescopic handle
10. Power connector
2.0 Ah
11. Shoulder strap
CD802AA
12. Carabiner
0.3 kg
13. Chain cover
14. Battery
15. Battery charger
CD802AA
16. Battery release button
220-240V, 50Hz 0.4A
17. Battery LED indicators button
21V 2.5A
18. Battery LED indicators
19. Charger LED indicators
60 minutes
120 minutes
3. ASSEMBLY
CD801AA, CD803AA
0.36 kg
CD803AA
Lithium-Ion
20V
4.0 Ah
Inserting the battery into the machine (Fig. B-1)
CD802AA Ensure that the exterior of the battery is clean and
dry before connecting to the charger or machine.
0.65 kg
1. Insert the battery (14) into the base of the ma-
2. Push the battery further forward until it clicks
Removing the battery from the machine (Fig. B-1)
1. Push the battery release button (16).
2. Pull the battery out of the machine like shown
Checking the battery charging status (Fig. B-2)
• To check the battery charge status, push the
• The battery has 3 lights indicating the charge
• When the lights are not burning it means the bat-
Charging the battery with the charger (Fig. B-2)
1. Take the battery (14) from the machine.
2. Turn the battery (14) to upside down position
Before any work (maintenance, tool change,
assembly) on the power tool, remove the
battery from the power tool.
The battery must be charged before first
use.
chine as shown in Fig. B-1.
into place.
in Fig. B-1.
button (17) on battery shortly.
level, the more lights that burn, the more
charge the battery has left.
tery is empty and must be charged immediately.
and slide it onto the charger (15) as shown in
Fig. B-2.
EN
11