Fault; Cleaning And Care - Seto ALDEBARAN SMARTLINE RP LED Serie Gebrauchsanleitung

The following operating states are displayed (in emergency lighting mode):
LED lights up RED
LED flashes RED
INFORMATION!
Use this function to keep the rechargeable battery at a medium charge level, e. g. to shorten the charging time after
the mains returns or if you intend to store the lamp for a longer period of time. This protects the rechargeable battery
and increases its life.
C. Version ALDEBARAN® SMARTLINE RP110 LED DIM (luminaire with DIM function):
A rotary control / potentiometer (D) with switching function is integrated in the cover on the connection side for dimming. By
turning it clockwise, the luminaire can be switched on and regulated up to full luminosity. Switching on can be recognized by
a "click". Turning it anti-clockwise reduces the luminosity up to and including switching off the luminaire.
D. Version ALDEBARAN® SMARTLINE RP72 LED DIM (luminaire with DIM function):
For dimming, a touch dimmer (E) is integrated in the cover on the connection side. The luminaire is switched on or off by
briefly pressing the button. The last set DIM value is recalled after switching on. Pressing and holding the button dims the
luminaire as long as the button is pressed. After releasing the button and pressing it again, the dimming direction changes.
For versions DIM and EM

Fault

LED without function
Partial failure of the LED
Only for Version EM
Fault
Button TEST without function
Light duration in emergency light
operation only a few minutes
WARNING! Electric current!
Before any maintenance, cleaning and care, the device must always be disconnected from the power supply by pulling the
mains plug.
Do not use any solvents, alcohol or other chemicals to clean the plastic parts / metal parts.
To remove dirt, dust, oil and grease, etc., use a soft, dry, lint-free cloth.
16
if the emergency lighting element is operated via the rechargeable battery
(emergency lighting mode)
when the rechargeable battery is empty (emergency lighting mode ended)
Fault
Possible cause
Disconnection from the mains supply Check the connection to the power
Defective LED
Possible cause
Integrated rechargeable battery
defective
Rechargeable battery not fully
charged
Integrated rechargeable battery
defective

Cleaning and care

Solution
supply
Repair necessary
Solution
Rechargeable battery replacement
required
Fully charge the rechargeable battery.
Please note the specified charging
time (see technical data).
Rechargeable battery replacement
necessary. Please contact your
SETOLITE team.