Installation; Initial Operation; Operation - Seto ALDEBARAN SMARTLINE RP LED Serie Gebrauchsanleitung

Installation with belt system (hanging light)
In order to be able to use the luminaires of the ALDEBARAN®
SMARTLINE for your purposes, nylon straps are available,
which are equipped with a metal fastener for locking (item
no. 1410920038 – 2 pcs.).
We would be happy to advise you on further installation
options!
The luminaire is only to be connected to an alternating current – with the voltage according to the rating plate – to a
properly installed safety socket. Please note that your system corresponds to the relevant VDE guidelines.
If you have any questions about this, please contact your energy supplier or your electrician.
Of course we are at your disposal if you have any questions.
ATTENTION!
In the case of versions of the luminaire with other plug-in systems (not Schuko®), the voltage according to the rating
plate must be observed.
WARNING!
• Lay the cables in such a way that there are no tripping hazards and they are protected from mechanical damage
such as tearing off or being run over.
• If necessary, secure the cables with tape or cable ties.
• Make sure the luminaire is securely set up and fastened before use.
• Also observe the applicable regulations on occupational safety!
Electrical connection
Connect the mains plug of the connecting cable to your mains connection socket.
The luminaire is ready for operation once it has been connected to the mains power supply.
By connecting the supply line to the supply network, the
luminaire is in the operating state. The Schuko® socket
mounted in the cover must be used to connect other
electrical devices.
ATTENTION!
Be sure to observe the information on the socket
(yellow label), which is located on the side of the
housing in the immediate vicinity of the socket.
14

Installation

Initial operation

Operation

(Example)