iFactory3D One Pro Aufbauanleitung Seite 20

V_97971.01
Y-hardstop
Before operating the machine make sure to loosen the screws in two Y-hardstops.
They do not need to be removed completely; just make sure that the printed part can move up and
down the profile smoothly.
Tighten the screws again as soon as the prinhead position is set (see software manual).
Y-hardstops prevent the nozzle from crashing into the printbed if an error occurs during printing.
Make sure they are always tight when the machine is printing.
Also make sure they are always loose when you want to recalibrate the nozzle position.
20