System Configuration - Veratron VL FLEX 52MM Serie Bedienungsanleitung

SYSTEM CONFIGURATION

1. READ THE VL FLEX CONFIGURATION
Launch the "Intelligent Battery Monitor" App and read the
current configuration of the device by "tapping" the
smartphone onto the front lens.
The READ operation is mandatory before the WRITE
operation is allowed.
After the readout, the App will be set with the current VL Flex
configuration.
NOTE: The antenna position on the smartphone depends on
the model.
Please refer to the smartphone manufacturer manual.
2. CONFIGURE BATTERY PARAMETERS
Use the first box to define which IBS is used.
For the IBS Sensor to correctly work the type of battery must
be defined. Use the second box to choose this parameter.
Write the batteries capacity in the last field of this section.
NOTE: The type of the battery and its capacity can be found
printed on the batteries housing.
3. CONFIGURE THE LEVEL SENSOR (OPTIONAL)
Check the Resistive Input Switch in order to configurate the
VL Flex according to your Level Sensor.
The first field is for defining, weather a Fuel Level Sensor or a
Fresh Water Level Sensor is used.
In the second field you must choose the resistance values of
the used sensor.
NOTE: The sensors resistor values depend on the Model.
Please refer to the sensor manufacturer manual.
4. SETUP THE ALARMS
You can activate or deactivate the alarms by using the App
switches.
Use the field next to the switch, to define the value, at which
the alarm should be triggered.
CONFIGURATION
B001025