Installation Guide - Veratron VL FLEX 52MM Serie Bedienungsanleitung

INSTALLATION GUIDE

Before beginning, disconnect the negative terminal on the battery, otherwise you risk a short circuit.
If the vehicle is supplied by auxiliary batteries, you must also disconnect the negative terminals on these
batteries! Short circuits can cause fires, battery explosions and damages to other electronic systems.
Please note that when you disconnect the battery, all volatile electronic memories lose their input values
and must be reprogrammed.
•
The IBS has to be mounted and handled in an ESD protected area
•
The IBS may not be contaminated with foreign particles (e.g. oil, silicon, grease, coolant, etc.)
•
The IBS may not be damaged
•
The pole clamp may only be torqued to the battery pole
Remove the ground cable and its clamp from the batteries
negative pole.
Mount the wire harness' ground cable on the IBS ground bolt.
Use the battery pole adapter to fasten the dedicated ring-type
connector.
Make sure not to damage the sensor while tightening the screw.
(Check the note further below.)
Now mount the system ground cable (the one that has been
attached directly to the battery before) onto the battery pole
adapter on the IBS.
Note: During the mounting of the screw nut, the torque (max. 17
Nm) must be completely intercepted by an appropriate
device/acceptance.
The torque must be intercepted only over the shore edges
shown in the picture to the right.
WARNING
ELECTRICAL INSTALLATION
B001025