Wiring - 24V Variant - Veratron VL FLEX 52MM Serie Bedienungsanleitung

A: IBS negative pole screw-on bolt (M8)
B: IBS Hirschmann mating connector
C: Positive pole terminal 12V (red wire)
WIRING – 24V VARIANT
A. VL Flex 52 connector – Tyco / Hirschmann 8-
poles MQS plug
B. Connector for pushbutton
C. Wire for "day/night-signal" (pink)
D. Wire for 12V-Power supply (connect to
ignition) (red)
Ring-type connector (red) with integrated 3A
E.
Fuse - to batteries positive pole (12V)
The 24V kit variant includes an additional brown wire on
the harness with an integrated fuse.
This wire is required to allow the IBS to monitor the
second 12V battery, which is connected in series to the
first 12V battery to create the 24V.
It shall be connected to the positive battery pole with
the higher potential (the 24V).
A: IBS negative pole screw-on bolt (M8)
B: IBS Hirschmann mating connector
C: Positive pole terminal 12V (red wire)
D: Positive pole terminal 24V (brown wire)
B
A
F. 3-Pin Hirschmann Plug – for the IBS (872-858-
546)
G. Ring-type connector (brown) with integrated
3A Fuse - to batteries positive pole (24V)
H. Ring-type connector (black) – to IBS's negative
pole terminal (M8 screw)
Resistive level sensor plug (AMP SuperSeal 1.5
I.
series 2 Pin)
B
A
ELECTRICAL INSTALLATION
C
C
D
B001025