Setting The Off Timer - Makita DRC300 Betriebsanleitung

3. Press the confirmation button to finalize the time of day.
Using the ON timer
1. Press the ON timer button to enable the ON timer function. The ON timer
lamp lights up and the setting time blinks twice.
• To cancel the ON timer function, press the ON timer button again to turn off
the ON timer lamp.
2. Select the operating mode of the robotic cleaner. (See pages 16 and 17.)
3. As the start/stop button is pressed, cleaning by the ON timer function is
reserved. (Sleep state)
To cancel the ON timer function in the sleep state, press the start/stop button
again to put the robotic cleaner into the stand -by state. To see the setting time
after reservation, press any button except the start/stop button. Then, the
setting time will light up for 3 seconds.
NOTICE
• The reserved information is canceled when the power is turned off or the
remaining battery capacity is completely lost.
• When the batteries are low, the robotic cleaner cannot wait for operation
by ON timer reservation. For operation by ON timer reservation, it is
recommended to bring the batteries to full charge.
• Operation by ON timer reservation is not possible when the power is turned
off.
• When the ON timer is set, the operatable time will be somewhat reduced
because the robotic cleaner consumes the battery during the sleep state.
• Example of use: Make the robotic cleaner clean automatically in the morning.
(Set the ON timer at 7:30. and the OFF timer at 9:00.)
1
4
1. Starts up at 7:30. (ON timer) 2. Cleaning 3. Finishes cleaning at 9:00. (OFF
timer) 4. Returns to the starting point.
• During adjustment of the hours/minutes, holding down the up/down button
results in the hours/minutes changing quickly.
• When the time setting of the timer is already completed, you only have to
follow the procedure for "Using the ON timer" on this page.

Setting the OFF timer

As a preselected time comes after the start of cleaning, the robotic cleaner ends
cleaning and goes back to the starting point. Before setting the timer, set the time
of day. (See page 22.)
1. Put the robotic cleaner into the stand -by state. (See page 15.)
2. Hold down the OFF timer button to change the time setting of the OFF timer.
• The changing procedure is the same as the time setting procedure (See page
22).
• The OFF timer can be configured in increments of 10 minutes.
3. Press the confirmation button to finalize the time of day.
Using the OFF timer
Press the OFF timer button to enable the OFF timer function.
The OFF timer lamp lights up and the setting time blinks twice.
• To immediately start cleaning and use the OFF timer, select the cleaning
mode and start cleaning.
• To use the OFF timer in combination with the ON timer, refer to page 18.
• To cancel the OFF timer, press the OFF timer button again when the robotic
cleaner is in the stand -by state.
19 ENGLISH
2
3