Maintenance - Bosch aquatak 1300 si Bedienungsanleitung

EURO • Printed in Italy • BA F016 L69 837 • AQUATAK 1300/1500 • OSW 12/01
F016 L69 837.book Seite 4 Donnerstag, 20. Dezember 2001 8:37 08
Stopping
Release trigger 2. Press the trigger safety lock. The
power gun is now locked and can not be operated
K
accidentally. (see figure
Press button ( ) on the main switch 5.
Close water tap. Unplug the machine from the elec-
tric supply.
Press the trigger safety lock 1 to release the trig-
ger 2. Fully press the trigger 2 until there is no more
water in the machine. Release trigger 2. Press the
trigger safety lock 1. (see figure
Disconnect water supply hose from machine and
water supply.
Advice using pressure washer
Operating with Detergents
Only use Bosch approved detergents. Unsuita-
ble detergents may damage the unit and the ob-
ject being cleaned.
Fill the detergent tank 11 with detergent, dilute as
H
recommend. (see figure
To spray detergent move vario-jet-fan nozzle to low
pressure mode. (see figure
We recommend that you use detergent sparingly for
the sake of the environment. Observe the re-
commended dilution on the detergent label.
By offering you an individualised range of cleaning
and preserving agents, Bosch guarantees trouble-
free operation of the unit.
Recommended cleaning method
Step 1: Loosening dirt
Spray on detergent sparingly and allow to react for a
short time.
Step 2: Removing dirt
Spray off the loosened dirt with the high-pressure
spray.
Note: When cleaning a vertical surface spray off
dirt/detergent from the bottom and work in a up-
wards direction.
Never use roto nozzle to clean motor vehicles.
Ensure that the machine is on level
(see figure F )
Do not overreach with the high pressure hose as
could make the machine unstable.
Suction of water
To draw water, unscrew the water connection 8 and
fit a suction hose. The water temperature should not
exceed 60 °C.
Use the power gun without the extention lance until
water appers without bubbles.
Never use the machine without the filter as this
will damage the internal parts of the machine.
15 • F016 L69 837 • TMS • 14.12.01
)
K
)
)
G )
ground.
English - 4

Maintenance

Stop, remove plug from the power sup-
ply and disconnect from water supply.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose
fixings, and worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the pressure washer should happen to fail despite
the care taken in manufacture and testing, repair
should be carried out by an authorised service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number from the
nameplate of the machine!
Cleaning/inspecting the strainer
Expose the strainer by removing the connector 7.
A
(see figure )
Rinse and replace. If
L
(see figure )
Never use the pressure washer without the
strainer or a damaged strainer.
Transport
To move the machine use the top handle and roll the
machine on the wheels.
To transport the unit up or down steps or over obsta-
cles, it must be lifted by the top handle.
If the unit is is be stored or transported horizontally
the detergent tank should be drained first.
After use storage
Clean the exterior of the machine thoroughly using a
soft brush or cloth. Do not use water, solvents or pol-
ishes. Remove all debris, especially from the venti-
lation slots.
Frost will damage a pressure washer that has not
been completely emptied of water. The machine
should be stored in a frost free room.
Do not place other objects on top of the machine.
Ensure cables are not trapped when storing.
Do not kink high pressure hose.
damaged replace.