Controller Lamps - Jacobsen AR522 Handbuch

9 PROBLEM SOLVING
9.2

CONTROLLER LAMPS _____________________________________________________

The controller is a solid state device that monitors and
controls electrical functions. The controller receives input
signals from various switches and sensors throughout
the machine and transmits output signals to operate
relays, solenoids and warning lights. It controls and
resets timers and contains built in logic to control certain
machine functions.
Each input and output signal is displayed through lamps
located on top of the controller. A closed input switch
indicates an active circuit and will turn an input lamp on.
An open switch an inactive circuit and will turn a lamp off.
Outputs are active when their lights are on.
It is important to note that in some cases a lamp or group
of lamps must be on or off for a condition to be true. For
Lamp On - Circuit is active
Lamp Off - Circuit is inactive
Lamp
1,2,3,4
Program Select (1, 3 and 4 are not used)
5
Brake Switch
6 Seat Switch
7
Traction Control Switch
8
Mow Switch
9 Joystick - Lower
10
Joystick - Raise
11
Hydraulic Oil Level Switch
12
Neutral Switch
13
Not Used
14
Keyswitch - Glowplug
15
Keyswitch - Start
16 Joystick Active
17
Hydraulic Filter Switch
18
Engine Oil Pressure Switch
48
Controller Functions by Lamp Number
INPUTS
Circuit
INPUTS
example, to start the mower the Mow Switch must be
OFF (lamp 8 off) while the Neutral Start Switch (lamp 12),
Brake Switch (lamp 6) and Fuel Valve Hold Coil (lamp 27)
must be ON.
NOTICE
For factory assistance with troubleshooting controller
problems, please note the controller hardware
revision and software version located on the lower
right corner of the controller. [SEE 7.14] Controllers
with equal or greater revision levels will be backward
compatible.
OUTPUTS
Lamp
19 Hydraulic Filter Light
20 Hydraulic Oil Level Light
21 Not Used
22 Glowplug Light
23 Lower Solenoid
24 Raise Solenoid
25 Glowplug Relay
26 Start Relay
27 Fuel Solenoid - Hold
28 Not Used
29 Audible Alarm
30 Mow Solenoid
31 Fuel Solenoid - Pull
32 Power-Ignition
33 Power-Lights
OUTPUTS
Circuit