Starting; Stopping / Parking - Jacobsen AR522 Handbuch

5.4

STARTING________________________________________________________________

NOTICE
IMPORTANT: Do not use starting assist fluids. Use
of such fluids in the air intake system may be
potentially explosive or cause a "Runaway" engine
condition and could result in serious engine damage.
!
WARNING
To prevent injuries, sit in the seat, engage parking
brake, place traction pedal in Neutral, and PTO switch
in OFF position before attempting to start the engine.
1. Sit in operator's seat, make sure the PTO switch (P)
is OFF (down) and the parking brake switch (W) is
ON. Remove feet from pedals. Always use the seat
belt when operating mowers equipped with a ROPS.
2. Set throttle lever (T) to half throttle.
3. Turn ignition switch (U) to RUN ( ) position.
Note: At this time the warning lights on the
combination gauge (V) and glow plug light (M) will
come on. Check that lights are operating.
NOTICE
Do not hold key in "START" position for more than 10
seconds at a time. After 10 seconds the starting circuit
will shut down and must be reset by returning the key
to the OFF position.
5.5

STOPPING / PARKING ______________________________________________________

To stop:
Remove your foot from traction pedal. The mower will
automatically brake when the traction pedal returns to
Neutral. Always engage parking brake, shut off engine,
and remove key before leaving operator seat for any
reason.
To park the mower under normal conditions:
1. Disengage the PTO switch (Q) then raise the
implements in the transport position and move away
from the area of operation.
2. Select a flat and level area to park.
a. Release traction pedal to bring the mower to a
complete stop.
b. Disengage all drives, lower implements to the
ground, engage parking brake, reduce throttle to
idle.
Wait until glow plug light (M) goes out, then
immediately turn ignition key (U) to "START" ( )
position. Release as soon as engine starts. Allow 30
seconds between start-up attempts to allow time for
engine starter motor to cool.
All warning lights should go off after engine starts.
Allow engine to gradually become warm before
operating at high RPM.
P
T
3. Engage parking brake, stop the engine, and always
remove the ignition key.
If an emergency arises and the mower must be parked in
the area of operation, follow the guidelines outlined by
the grounds superintendent. If the mower is parked on an
incline, chock or block the wheels.
OPERATION
M
V
W
U
Figure 5A
5
25