Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
EN: Installation Sheet
Mounting location
The bolt contact is suitable for the mounting at the door closing
plate to allow the lock detection of the corresponding lock
device.
The activation / operation of the bolt contact is triggered by the
lock bolt. The status of the bolt contact can be processed by
the central unit of an intruder and hold-up system.
Delivery content (see Figure 2)
1.
Bolt contact
2.
Lever extension (plastic)
3.
Lever extension (metal)
4.
Plastic clip (installation bracket)
5.
Sheet metal screw 2.2 x 4.5
6.
Countersunk screw M3 x 6
7.
Installation Instructions
Dimensions
The dimensions can be found in Figure 3.
For the strain relief, a circuit loop can be placed by wrapping
the cable around the plastic clip (installation bracket).
2 / 4
6
3,5 +/- 2 mm
Mounting location and installation method
A schematic drawing can be found in Figure 4.
The standard installation takes place frontally at the closing
plate on the door. The distance between the mounting holes is
11 ± 1.5 mm.
Attention:
The bolt contact has to be mounted by the enclosed
screws only! If necessary, screw on the lever extension (3,
metal) with the sheet metal screw (5) or clip the lever extension
(2, plastic) by pushing and pulling it forward and backward.
Special feature: In addition to mounting the bolt contact from
the front, it is possible to mount the bolt contact from the side
as well.
A circuit loop for the strain relief can be wrapped around the
plastic clip (mounting bracket) or alternatively around the
installation components on the bolt contact ground (see
Figure 5).
P/N 75009040.Yxx • REV A • ISS 20DEC12
Werbung
