teutonia TeamCosmo Bedienungsanleitung Seite 12

INT
TEAM COSMO
Swivel wheel
Swivel wheel unlocked
We recommend that you do not lock the wheels while
moving as this will give a more comfortable ride.
Seat cover
The seat cover can be removed completely from the seat
unit for washing. Simply open the snaps on the seat unit.
Attention: When mounting the seat cover, thread the
ends of the 5-point restraint back through the relevant
openings without twisting the straps.
Height-Adjustable, Foldable Handle
Applying the Parking Brake
wheel rim. Make sure that the brake has locked secure-
ly. You can release the brake by depressing the brake
lever 2.
12
Swivel wheel locked
To change the height of the
handle, press in the adjusting
buttons on both sides of the
handle.
The brake is activated by
pushing down the long brake
lever 1. If it is difficult to ap-
ply the brake, wheel the
stroller back and forth a few
centimetres so that the brake
bars engage properly in the
Attaching and removing the seat or
carry-cot (upper section)
Place the upper section (seat or carry-cot) onto the pram
chassis in such a way that the lateral bars 1 of the upper
section click into the slots provided 2 on each side of the
chassis and push the upper section in as far as it will go.
The locks then close automatically. (The locks must
"click" into place.)
WARNING:
Check that the pram body or seat unit at-
tachment devices are correctly engaged be-
fore use.
The upper section is secure if the red field in
the release lever is no longer visible. To remove the up-
per section press the safety lever (3) up and then the re-
lease lever (4) down until the lever locks. (red field ap-
pears). Then pull the upper section out of the slots and
remove it.
How to use the hood
Push the insert pieces for the hood joints into the corre-
sponding openings on the armrest or on the carry-cot.
Attention: You must secure the press studs on the back
end of the cover onto the rear of the backrest as the cov-
er is also used as a protection against falling out.
If you need to remove the hood, undo the press studs on
the rear of the backrest; press the release buttons on the
insert pieces of the hood joints and pull the joints out of
the openings. You can open the zip at the top of the hood
for ventilation.
Adjusting the Backrest
4 3
Pull the grip 1 upwards and
move the backrest 2 into the
required position.
make sure that the backrest
re-engages properly.
Please