Fronius OPT/i TPS SpeedNet Connector Installationsanleitung Seite 14

Installing the OPT/i TPS SpeedNet connector on the
power source
Requirement The „4-fold switch" option must be installed in the power source.
Preparing to
1
install
2
3
Connect the supplied cable harness to the print SCRATSW
Installation at the
1
front side of the
housing
Fold out the control panel
14
Turn off power source and disconnect from mains
Take off the right side panel
1
3
2
3
1
2
2
Remove the blanking cover below the control panel
(push from the inside outwards)