Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation procedure
1 Confirm the strength of the proposed installation location
The weight of the wall mount adaptor is approximately
3.5 kg, but the weight of the LCD monitor for attaching to
the wall mount adaptor is approximately 15 kg. Make sure
the wall can withstand five times the weight of the LCD
monitor together with the wall mount adaptor.
Check the wall strength at the six attachment points by
referring to the following dimensions diagram of the wall
mount adaptor, and provide adequate reinforcement if the
strength is not sufficient.
Note
• There are 12 installation holes in the wall
mount adaptor.
If the wall material is wood, and adequate
strength cannot be ensured when installing
at the 6 points indicated on the right, use
also the spare holes.
However, exercise care because some wall
materials may crack if screws are located
too close together.
* For details on the dimensions for
installing the LCD monitor, refer to the
"External dimensions".
2. Install the wall mount adaptor to the wall
• Install making sure the arrows indicated on the wall mount adaptor are facing up.
• If the wall consists of a material such as concrete and bolts or nuts must be
embedded beforehand, determine the hole positions by aligning using the actual
wall mount adaptor, or calculate the hole positions based on the dimensions
diagram, and then embed the M6 bolt or nut. When embedding bolts, locate so that
the bolts protrude from the wall by 10 to 15 mm (
First, fasten the screw at the top center hole
1
Using a level, correct any adaptor inclination, and then fasten screws at the
２
remaining 5 locations.
• Use commercially available M6 screws suited to the wall surface
Note
material for installing the adaptor to the wall.
3. Adjust the angle of the wall mount adaptor
The angle of the wall mount
adaptor can be adjusted from
"no incline" to "20° incline" in
5 settings at intervals of 5°.
To change the angle, loosen
the angle fixing screw
and vertical fixation screw
of the angle base, and
3
move to the desired angle.
After positioning, securely
tighten (2.7 – 3.3 N·m) the
angle fixing screw
. If "no
2
incline" is set, also firmly
tighten (2.7 – 3.3 N·m) the
vertical fixation screw
3
7
/
.
Angle adjustment
hole positions
2
"No incline"
"5° incline"
"10° incline"
"15° incline"
"20 incline"
Angle fixing
2
.
screw
Angle base
Wall mount adaptor
Unit: mm (inch)
* Be sure to use screws to secure them.
to
5
/
inches).
16
8
"No incline"
Vertical
3
fixation screw
480 (19)
440 (17
3
/
)
8
1
163 (6
/
)
176 (7)
2
216 (8
5
/
)
8
Wall attachment holes
(at 6 points)
A
At "5° incline"
At "15° incline"
Strap
7
Werbung
Inhaltsverzeichnis
