Assembly Procedure - Panasonic TY-ST42P50 Montageanweisungen

Assembly Procedure

1. Assemble the Pedestal
● Make sure you do not scratch the surface of the
stand base.
● Stand poles for plasma displays and LCD displays
are different.
Please choose the correct stand poles for your
display.
How to identify the stand poles
For plasma display
・ Pole part is longer
・ Two screw holes
Part number: TBLA3679/TBLA3680
For LCD display
・ Pole part is shorter
・ Three screw holes
Part number: TBLA39551/TBLA39561
Align stand base Ⓐ with the stand poles Ⓑ on the left and right sides, and use the stand pole installation screws
Ⓒ (4 screws) to attach the stand poles as shown in the diagram.
(Tightening torque: 1.5 to 1.8 N•m)
2. Install the Display
Place the assembled pedestal with the rear side (side with the model nameplate attached) facing towards
yourself, align the display with the stand poles, insert the stand poles into the display, and insert and tighten the
unit installation screws Ⓓ (4 screws).
(Tightening torque: 1.5 to 1.8 N•m)
Rear of Display
Model Nameplate
With the side that has the model nameplate attached
facing you, insert the stand poles as far as possible
into the display.
Stand pole
installation screw Ⓒ
Stand pole
L Ⓑ
Stand base Ⓐ
Rear of Display
Unit installation screw Ⓓ
Stand pole
R Ⓑ
15