Inhaltsverzeichnis
Werbung
13. Prise du pack de batteries
14. Ceinture de support
15. Adaptateur de charge
16. Fiche de charge
Contenu de l'emballage
1
Jeu d'outils de jardin sans fil multifunctions
1
Pack de batteries
F
1
Chargeur de batterie
1
Mode d'emploi
1
Consignes sécurité
1
Carte de garantie
1
Coup branches
1
Cisaille d'herbes
Vérifiez si la machine, les composants et les accessoires ne sont pas endommagés.
2. CONSIGNES DE SÉCURITÉ
Explication des symboles
Dans ce manuel et/ou sur la machine, sont utilisés les symboles suivants :
Lisez les instructions.
Conforme aux normes essentielles de sécurité applicables des directives
européennes
Machine Classe II – Double isolation – Aucune prise terre n'est nécessaire
Indique les risques de blessures, de mise en danger de votre vie et de dommage de
l'appareil en cas de non respect des instructions de ce manuel
Indique les risques de chocs électriques
Toujours recycler les piles rechargeables
Uniquement pour une utilisation intérieure
40
Warning! Immediately after cutting the back of the cutting blade may be very hot.
Wear protective gloves before handling the blade.
To remove the cutting blade attachment (same procedure for other accessories):
•
Press both attachment release buttons at the same time. Be careful not to drop the blade
when doing this.
•
Te re-attache see Assembly
Tips on cutting
•
Hold the tool away from yourself using both hands. Stand in a secure and stable position.
•
When cutting move steadily along the line of cut, so that the stems are fed directly into the
cutter blades. The double edge cutting blade enables cutting in either a side to side action
or an up and down motion.
•
Cut the sides of the hedge first then cut the top.
•
To keep the sides flat, cutting upwards with the growth is recommended. To reach a level
finish, fasten a piece of string along the length of the hedge cut the hedge just above the
string to give an even height.
•
Always take care to avoid cutting into objects such as wire, which could cause damage to
the cutting blades and drive.
Shaping
The hedge should be trimmed to achieve a trapezoidal shape, which is wider at the bottom
than the top.This will improve the light penetration to the lower region of the shrub. An
approximate guide is 10 cm in for every metre in height. The bush can be rounded or column
shaped.
Cutting sequence
•
First trim both sides from the bottom upwards, this prevents any debris from falling into
the area which has yet to be cut.
•
Then trim the top, if the branches of the hedge are extremely long, trim them back in
multiple stages.
Note: Doing this also has the benefit of having shorter cutting which will decompose better on
a compost heap.
•
If older hedges need to be cut back a substantial amount, use pruning shears to trim
thicker branches to the desired length before going to work with the hedge trimmer.
•
Ensure that the blade does not come into contact with anything which could damage it,
such as fencing wire or metal plants support.
After use
Clean the blades and lightly lubricate with household oil or spray lubricant.
Ferm
Ferm
GB
13
Werbung
Inhaltsverzeichnis
