DeWalt DW872 Originalanweisungen Seite 29

13. Do not overreach.
Keep proper footing and balance at all times.
14. Maintain tools with care.
Keep cutting tools sharp and clean for better
and safer performance. Follow instructions for
lubricating and changing accessories. Inspect
tools periodically and if damaged have them
repaired by an authorized service facility. Keep
handles and switches dry, clean and free from
oil and grease.
15. Disconnect tools.
When not in use, before servicing and when
changing accessories such as blades, bits and
cutters, disconnect tools from the power supply.
16. Remove adjusting keys and wrenches.
Form the habit of checking to see that adjusting
keys and wrenches are removed from the tool
before operating the tool.
17. Avoid unintentional starting.
Do not carry the tool with a finger on the switch.
Be sure that the tool is in the "off" position
before plugging in.
18. Use outdoor extension leads.
Before use, inspect the extension cable and
replace if damaged. When the tool is used
outdoors, use only extension cords intended for
outdoor use and marked accordingly.
19. Stay alert.
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired or
under the influence of drugs or alcohol.
20. Check for damaged parts.
Before use, carefully check the tool and mains
cable to determine that it will operate properly
and perform its intended function. Check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting and any
other conditions that may affect its operation. A
guard or other part that is damaged should be
properly repaired or replaced by an authorized
service centre unless otherwise indicated in this
instruction manual. Have defective switches
replaced by an authorized service centre.
Do not use the tool if the switch does not turn it
on and off. Never attempt any repairs yourself.
WARNING! The use of any accessory
or attachment or performance of any
operation with this tool other than those
recommended in this instruction manual
may present a risk of personal injury.
21. Have your tool repaired by a qualified
person.
This electric tool complies relevant safety rules.
Repairs should only be carried out by qualified
persons using original spare parts; otherwise
this may result in considerable danger to the
user.
Additional Safety for Metal Saws
• Do not use saw blades which are damaged or
deformed;
• Use only saw blades recommended by the
manufacturer which conform to EN 847-1;
• Do not use saw blades manufactured from high
speed steel;
• Wear suitable personal protective equipment
when necessary, this could include:
– hearing protection to reduce the risk of
induced hearing loss;
– eye protection;
– respiratory protection to reduce the risk of
inhalation of harmful dust;
– gloves for handling saw blades (saw
blades shall be carried in a holder wherever
practicable) and rough material;
MAINTENANCE AND SERVICING
• Operator's instructions on factors influencing
exposure to noise (e.g. use of saw blades
designed to reduce the emitted noise, saw
blade and machine maintenance);
• Report faults in the machine, including guards
or saw blades, as soon as they are discovered.
SAFE OPERATION
• Select the correct saw blade for the material to
be cut;
• Do not use the saw to cut other materials than
those recommended by the manufacturer;
• Lifting and transportation information. To lift and
support the metal saw see figure F.
• Do not use the saw without the guards in
position, in good working order and properly
maintained;
• Keep the floor area around the machine level,
well maintained and free of loose materials e.g.
chips and cut-offs;
• Provide adequate general or localised lighting;
• The operator is adequately trained in the use
adjustment and operation of the machine;
EN G LI SH
27