Assembly And Adjustments - DeWalt DWS520 Originalanweisungen

• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power
input of this tool (see technical data).The minimum
conductor size is 1.5 mm ; the maximum length is
2
30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: Prior to assembly and
adjustment, always unplug the tool.
Bevel Adjustment (fi g. 1)
The bevel angle can be adjusted between 0° and
47°.
1. Loosen the bevel adjustment knobs (e).
2. Set the bevel angle by tilting the saw shoe (d)
until the mark indicates the desired angle on
the bevel scale (y).
3. Tighten the bevel adjustment knobs (e).
Changing the Saw Blade (fi g. 2, 3)
1. Press the lock button (l).
2. Press the plunge saw down to stop (blade
change position).
3. Turn the lock lever (m) clockwise until it stops.
4. Press the lock lever (m) down and rotate the
blade until the lock position is found.
NOTE: The blade (k) is now locked and cannot be
turned by hand.
5. Turn the blade clamping screw (n) anti-
clockwise to remove.
6. Remove the outer flange (o) and used blade (k).
Place the new blade on the inner flange (p).
7. Replace the outer flange (o) and blade clamping
screw (n). Turn the screw clockwise by hand.
NOTE: The direction of rotation of the saw blade
and the rotation of the plunge saw MUST be the
same.
8. Tighten the blade clamping screw firmly using
the hex key.
9. Release and turn the lock lever (m) anti-
clockwise until it stops.
10. Move the plunge saw back to top position.
11. Push plunge trigger (a) forward, to lock saw
blade change.
Adjusting the Riving Knife (fi g. 3)
For the correct adjustment of the riving knife (q), refer
to the figure 3. Adjust the clearance of the riving
knife after changing the saw blade or whenever
necessary.
1. Follow Changing the Saw Blade steps 1–4.
2. Loosen the riving adjustment screw (r) with an
hex key and set the riving knife as shown in
figure 3.
3. Tighten the riving knife screw (r).
4. Turn the lock lever (m) anti-clockwise until it
stops.
5. Move the plunge saw back to top position.
6. Push plunge trigger (a) forward, to lock saw
blade change.
Depth of Cut Adjustment (fi g. 4)
The cutting depth can be set at 0 – 59 mm without
guide rail attached; with the guide rail attached:
0 – 55 mm.
1. Loosen the depth adjustment knob (f) and move
the pointer to obtain the correct depth of cut.
2. Tighten the depth adjustment knob (f).
NOTE: For optimal results, allow the saw blade to
protrude from the workpiece by about 3 mm (fig. 4).
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
Proper Hand Position (fi g. 5)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
EN GL IS H
31