Alarm Configuration - SKYTRONIC 351.174 Betriebsanleitung

ALARM CONFIGURATION

The traditional alarm events，include video detection（motion detection、video loss、Video shade）and external alarms.
[main menu]-[management configuration]-[alarm configuration]Enter the configuration interface.
Video detect
[Channel] Select a channel.
[Alarm type] Motion detection, video loss and video blind.
[Motion detection] Detect the motion in the picture, and send alarm according to setting.
[Video loss] Detect the video loss and send alarm according to setting.
[Video blind] Detect the video which was covered and send alarm according to setting.
[Enable] Control the alarm open and close
[Sensitivity] Highest, higher, middle, low, lower, lowest
[Set area] There are totally 22*18=396 area can be set, which needs motion detection.
[Process] Set the alarming time, linkage and the handling method.
[Set linkage] Show in the appendix 9.1 about set alarm linkage.
[Preview] It will show a test on the current setting.
[Copy] Copy the setting to other channels.