HBM Machines ARC 200 Handbuch Seite 39

When the DC inverter welder works with AC welder, please don't let the output cable of
WARNING
Two different machine connected together prevented from damage welder
Once you touch the electric parts will result in electric shock
DANGER
● Don't touch the electric parts.
● Make sure the welder connect to earth before using.
● Off power supply while assembly and maintainance.
● Don't use the welder while opening the case.
● Please use the good insulating gloves.
ARC, Spatter and slag may burn eyes and skin, abnormal noise may hurt hearing
CAUTION
● Please use the welding mask to protect your face and eye
● Please use the welding clothes to protect your body
● Please use hearing protecting tool when it is noising
Using welder in a narrow place or higher have the potential to cause electric shocks,
DANGER
stinging lead to falls and other accidents.
● Please use the VRD device or build-in VRD welder in the following location
● 2m or higher location with risk of falling, workers who may be exposed to bars and other
places of grounding electrical conductivity.
● Please check the VRD device per the safety rule while operating
The dust, smoke or gas caused by welding are bad for health
CAUTION
● Please use local exhaust ventilation equipment and respiratory protective equipment.
● When operating in narrow places, please check and accept monitoring of adequate ventilation,
wearing of respiratory protective equipment
● Please don't use the welder in the degreasing, cleaning and spraying area
It may result in fire, blasting or other accident during welding
CAUTION
● Please don't place any Combustible and flammable gases in the welding location.
● Please don't weld any airtight container, like oil tank or tube or others
● Please equip with fire apparatus in welding location.
CAUTION
Lifting Device:
The standard package for this welder is carton or wooden box without any connector
for lifting device, so when the welder arrive, please use the fork lift truck to move the
machine and then open it.
●When the welder equipped with rings for lifting, you can use the ring to transport the machine,
but please notice that don't use roller to move the welder since it may damage the welder
● Please make sure all accessories have been removed when lifting
● When the welder is being lifted, please make sure there is nobody below the welder and there
is someone to mention the passengers.
● Please don't use the crane to move the welder quickly.
● Please install the welder in accordance with the assembly direction.
Please make the generator's power is at least 2 times than the welder's rated power
WARNING
when using generators as power supply