Vxdlr - Dpg1C - Linak DESKLINE XDLB-Serie Bedienungsanleitung

Reminder intervals
The number of white blocks (one, two or three) each representing an interval. The three standard intervals are:
- Interval 1: Reminder after 55 minutes sitting
- Interval 2: Reminder after 50 minutes sitting
- Interval 3: Reminder after 45 minutes sitting
The default interval is reminding after 55 minutes, which means one white block lights up.
Adjusting the reminder interval
1. Press button to adjust interval of getting reminded to change position.
2. Toggle through intervals by pressing button.
3. Release button when desired interval is indicated.
When no white blocks are lit up, the reminder is turned off.
Through the app, it is possible to personalise the three intervals to custom values.
Interval 1: Reminder after 55 minutes sitting
Interval 3: Reminder after 45 minutes sitting
Resetting the reminder
1. Press - symbol for eight seconds to reset
reminder to default values.
After fi ve seconds, the light strip fl ashes red when
the reminder is reset.
Key lock
The operation of VXDLB - DPG1B can be locked to prevent unintended driving of the desk. As default the
key lock is disabled. If enabled, it automatically locks the VXDLB - DPG1B after a configured amount of time.
The key lock function can also be configured to indicate attempt to operate the locked VXDLB - DPG1B by showing
a red light.
Unlocking VXDLB - DPG1B
1. Press , and in sequence (max. one second between each button press).
12/38
VXDLB
Interval 2: Reminder after 50 minutes sitting
Reminder off
EN 114065
Instruction manual

VXDLR - DPG1C

The VXDLR - DPG1C has three operation buttons.
Introduction to the DPG Installation of the DPG
Each button has a specifi c function:
Symbol Description Function
Reminder Setting reminders
Bluetooth Connecting the Desk Control
®
Favourite Saving favourite positions
Display
The VXDLR - DPG1C has an OLED display, which shows the height during drive of the desk and many other texts
to guide the users.
Adjusting the displayed height of the desk
If the height shown in the display is not correct, it can be adjusted.
1. Press the and the buttons on the VXDLR - DPG1C at the same time for five seconds and the height in the display
starts to flash.
2. Tilt the VXDLR - DPG1C to change the displayed height without moving the desk.
Tilt up to increase the displayed
height, tilt down to decrease the displayed height.
3. Press any button to confirm the height or wait for 10 seconds for
automatic confirmation.
Changing the measurement unit
The measurement unit shown in the display can be set to either cm or inch.
1. Press and buttons on VXDLR - DPG1C at the same time for fi ve seconds and the current
measurement unit fl ashes in display.
2. When e.g. "CM" fl ashes in display, tilt VXDLR - DPG1C once to change measurement unit to inch.
"INCH" now fl ashes in display.
3. Press any button to confi rm measurement unit or wait for 10 seconds for automatic
confi rmation.
13/38
VXDLR
VXDLR - DPG1C
App via Bluetooth wireless technology
TM ®
EN 114065