Ztroubleshooting - Parkside PAL 2200 A1 Bedienungs- Und Sicherheitshinweise

zAssembly
Please note: Dispose of all packaging material.
The magnet allows for the cordless work light
7
to be attached to a metal surface. Make sure that
the surface is flat and even to ensure the light can
be securely fastened. The battery-powered work
light can also be fixed using the hook
simply be placed on a smooth surface.
zCharging the battery
„ Turn the product off if necessary by pressing the
ON/OFF switch .
4
„ Position the charging station
surface.
„ Place the cordless work light
charging station provided
USB charging cable
the charging station
end of the cable with a standard USB interface.
„ The battery charging process begins. The
charge level indicator
status (three levels) of the cordless work light
with a blue flashing light. The charging station's
readiness for use is indicated by the red LED
9
. The LED indicating readiness for use
10
continuously, if the charging station is
connected to a power source.
First level = approx. 35 %,
Second level = approx. 67 %,
Third level = 100 %
„ It is also possible to charge the cordless work
light without the charging station. To do so,
connect the USB charging cable with the USB
port and a standard USB interface.
6
8
, or
8
on an even
9
onto the
1
. Now connect the
9
with the USB port on
12
and connect the other
1 1
shows the charging
5
10
zSwitching the battery-powered
work light ON/OFF
Unfold the cordless work light.
„
„ The ON/OFF switch
work light to be turned on and off and for its
brightness to be controlled. Battery capacity is
indicated by the 3-level charge indicator
„ By pressing the ON/OFF switch
operate the LEDs as follows:
Press 1 x: 100 % COB-LED (2) is activated
Press 2 x: 50 % COB-LED (2) is activated
Press 3 x: LED (1) is activated
Press 4 x: The cordless work light is turned OFF.
zCleaning and storage
Switch off the product by pressing the ON/
„
OFF switch
product, and would like to store it.
„ Check the cordless work light for any soiling on
a regular basis. Remove any dirt to ensure the
product works correctly.
Clean the product with a clean, damp cloth and
„
a mild detergent.
1

zTroubleshooting

is lit
= Fault
= Cause
= Solution
= The product will not switch on.
= The product is switched off.
= Press the ON/OFF switch
product.
= The light is flickering.
= The battery is almost empty.
= Charge the battery (see section "Charging
the battery").
allows for the cordless
4
4
when you are not using the
4
to turn on the
4
.
5
, you can