Safety Instructions; Technical Data - Kayoba 021125 Bedienungsanleitung

SAFETY INSTRUCTIONS

• Never use the balance bike without
wearing a correctly adjusted and correctly
fitted helmet. Using helmets saves lives!
• Do not use the balance bike at night, or in
the dark, in wet conditions or on slippery
surfaces.
• A correctly fitted helmet covers the
forehead. An incorrectly fitted helmet
exposes the forehead and can result in
the risk of serious personal injury.
• The balance bike is intended to be used by
children from 3 to 6 years old.
• Children who cannot stand up by
themselves should not use the balance bike.
• Children shorter than 85 cm or longer
than 110 cm should not use the balance
bike.
• Children must only use the balance bike
when supervised by an adult.
• Use personal safety equipment (helmet
and kneepads). Do not use in traffic. The
balance bike should only be used indoors,
or in parks or playgrounds etc. Avoid wet
surfaces.
• The balance bike must be assembled by
an adult. Check before use that the
balance bike is in good condition.
Incorrect assembly can result in serious
personal injury.
• Use the bike carefully to avoid falling over
and collisions.

TECHNICAL DATA

Weight
Max load
Tyre size
DESCRIPTION
1. Saddle post
2. Saddle
3. Saddle post clip
4.
5.
6.
7.
8.
9.
10. Rim
11. Handlebar post screw
12. Handlebar clip screw
13. Top position marking for handlebar post
14. Handlebar post key
15. Handlebar tube
1.
1.
2.
4.5 kg
3.
30 kg
12" (30.5 cm)
4.
Frame
Grip
Handlebars
Handlebar post
Front fork
Tyre
FIG. 1
ASSEMBLY
Open the box from the top and lift out the
product. Remove the packaging material
and transport protection parts. Check that
all the parts are included in the delivery.
Lubricate all threads and moving parts
before assembling.
HANDLEBARS & HANDLEBAR POST
Remove the protective cover from the
handlebar post key and undo the screw
with a 6 mm hex key. Some models have
a 13 mm hex head instead of a socket
head.
Push the handlebar post into the front
fork tube until the marking for the top
position cannot be seen.
Check that the handlebars and front
fork are turned forwards and that the
handlebars are straight in the front fork.
Tighten the handlebar post screw.
Angle the handlebars to the required
position. Tighten the handlebars by
turning the handlebar clip screws in turns,
2 turns at once. Repeat this tightening
until the handlebars sit firmly in the
EN
13