Working With The Leaf Blower - Parkside FLB 2500 A2 Originalbetriebsanleitung

Always work at the lowest possible
motor rpm level, since the noise
level and power consumption both
increase / decrease with motor out-
put.

Working with the leaf blower

. The.leaf.blower.may.only.be.
used.for.the.following.pur-
poses:..
-. As.a.blower.to.pile.up.dry.
leaf.material.or.to.blow.mate-
rial.out.of.places.that.are.hard.
to.access.(e.g..under.cars)..
-. As.a.suction.device.to.suck.
up.dry.leaf.material..The.de-
vice.also.functions.as.a.shred-
der.in.the.suction.function..The.
dry.leaves.are.shredded.and.
their.volume.is.reduced,.pre-
paring.the.material.for.later.
composting.if.desired..The.
shredding.intensity.depends.
on.the.size.of.the.leaf.material.
and.its.residual.moisture...
Uses.other.than.those.de-
scribed.here.may.damage.the.
machine.and.put.the.operator.
at.risk.
During work, ensure that the device
is not struck against hard objects,
which can cause damage. Do not
suck up any solid bodies such as
stones, branches or pieces of branch,
fir cones or similar, since these can
damage the device, in particular the
shredding mechanism.
Repairs of this type are not covered
by the guarantee.
. Pull.out.mains.plug.immedi-
ately.if.the.impeller.wheel.
is.blocked.or.if.the.cable.is.
damaged.or.gets.wound.
around.something!.Danger.of.
electric.shock!
Blowing.operating.mode:
• Set the operating mode selector switch
(16) to the symbol
Operation").
• You get optimal results when you use
the blower with a separation distance
to the ground of 5 -10 cm.
• Direct the airstream away from your-
self. Ensure that you do not to stir up
any heavy objects and hurt somebody
or damage something.
• Begin work with the highest blowing
power, in order to rapidly pile up the
leaves lying around. Select a lower
blowing power to compact the previ-
ously piled up leaves.
• Before blowing, loosen leaves adher-
ing to the ground with a broom or
rake.
• The guide rollers at the end of the tube
make it easier to work on flat surfaces.
Suction.operating.mode:
• Set the operating mode selector switch
to the symbol
tion"). Check whether the collection
bag (18) is correctly assembled.
• Make sure the volumes of leaf mate-
rial sucked in at one time are not too
large. This will avoid clogging of the
blower / suction tube and blockage of
the impeller wheel (24).
• For ground suction of leaves or leaf
residues, place the enclosed flat nozzle
onto the end of the tube.
GB
(see "Initial
(see "Initial Opera-
59