Electrical Safety - Parkside FLB 2500 A2 Originalbetriebsanleitung

GB
sories;
- when the power or extension cable
is damaged; after contact with for-
eign bodies or in case of abnormal
vibration;
• Do not use the device in closed or badly
ventilated rooms. Do not use the device
near inflammable liquids or gases. In
case of non-observance of these direc-
tions, danger of fire or explosion exists.
• Keep the device in a dry location and
out of reach of children.
• Keep all cooling air inlets clear of dirt.
CAUTION! The following states
how damage to the trimmer and
possible injury to people can be
avoided:
• Do not stretch the body too far and
ensure that balance is maintained.
• Handle the unit with care. Clean the
ventilation slits regularly; keep to the
maintenance instructions.
• Do not overload your device. Work
only within the indicated range of
performance. Do not employ any low
power machines for heavy work. Do
not use your device for purposes for
which it has not been designed.
• Do not attempt to repair the appliance
yourself unless you have specific train-
ing to do so. Leave any work not listed
in this manual to our Service Centre
(see p. 65).
• Check the grass bag regularly for wear
or damage.
Electrical.safety:
CAUTION! The following states how
to avoid accidents and injuries due to
electric shock:
56
• Make sure that the mains voltage is com-
patible with the information of the label.
• Connect the device, as far as possible,
only to a plug socket with a ground-fault
circuit interrupter (g.f.c.i switch), with a
rated residual current at not more than
30 mA.
• Check the device and the power cable
with plug for damage before every use.
Avoid bodily contact with grounded
parts (e.g. metal fences, metal post).
• The coupling of the extension cord must
be protected against splashed water, it
must consist of rubber or be surrounded
by rubber. Employ only extension cords
which are stipulated for use in the open
air and are marked accordingly. The
flexible lead cross-section of the exten-
sion cord must at least 2.5 mm
roll out the cable drum completely before
use. Check the cable for damage.
• Keep the cable away from the field of
action and basically play it out behind
the operator.
• Use the tension relief provided for the
fixing of the extension cord.
• Do not carry the device by the cable. Do
not use the cable to pull out the plug from
the plug socket. Protect the cable against
heat, oil and sharp edges.
• Damaged cables, coupling and plugs
or connecting leads not corresponding
to specifications, must not be employed.
Remove the plug immediately from the
plug socket in case of damage to the
mains cable.
Do not touch the mains power supply
cable under any circumstances until you
have pulled the plug out of the mains
socket.
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
. Always
2