Operation; Initial Operation - Parkside FLB 2500 A2 Originalbetriebsanleitung

GB

Operation

. Danger.of.injury.
Wear.suitable.clothing.and.
work.gloves.when.working.
with.the.device..Make.sure.
that.the.device.is.functioning.
properly.before.every.use..
Make.sure.that.the.collection.
bag.and.the.tube.are.assem-
bled.correctly.and.the.carry-
ing.strap.is.adjusted.correctly.
for.work..If.a.switch.should.
be.damaged,.work.with.the.
device.must.not.be.carried.out.
any.longer..Make.sure.that.
the.mains.voltage.values.are.
compatible.with.the.label.on.
the.device.
Note noise protection laws and lo-
cal regulations.
. After.switching.off.the.de-
vice,.the.impeller.wheel.
continues.to.rotate.for.some.
time..Danger.of.injury.due.to.
rotating.tool..

Initial Operation

Before switching on device, make
sure it is not in contact with any ob-
jects. Ensure stable positioning.
The device can only be switched on
if the entire blower / suction tube
is correctly mounted. The impeller
wheel cover must be closed and the
attachment screws must be tightened.
C
1. Make a loop of the end of the ex-
tension cord and fasten this to the
58
cable support (15). By means of
this tension relief, an unintentional
pull-out of the electrical plug con-
nection is avoided.
2. Put on the carrying strap (1) and
adjust it to the optimum length.
3. Open the quick-release fastener
(7) and move the additional grip
(6) to the desired position. Re-
close the quick-release fastener.
4. Make sure that the device is
switched off and connect the de-
vice to the mains voltage.
5. In order to select the operation
mode, turn the operation mode
selector (16) to the symbol re-
quired.
Before changing the operating
mode, it is absolutely necessary
that the device be switched off.
Blowing operating mode
Suction operating mode
6. For switch-on, slide the on/off
switch (9) into position "l", the
device starts up.
To switch off, slide the on/off
switch (9) into position "0", the
device switches off.
7. With the airstream regulator (10)
set the optimal blowing and suck-
ing strength.
8. During operation, hold the device
with one hand on the casing grip
and the other on the additional
grip. Grip the handles inside of
the vibration-dampened areas
fitted with vibration dampers (
26 + 27).
A