Installation - Cebora SYNSTAR TWIN 270 T Betriebsanleitung

3�4

Installation

Connecting high power devices to the mains could have negative repercussions on mains power quality. Line
impedance values lower than the Zmax value indicated in the table may be required for compliance with IEC 61000-
3-12 and IEC 61000-3-11. It is the responsibility of the installer or user to ensure that the device is connected to a
line of correct impedance. It is advisable to consult your local electricity supplier.
Make sure that the mains voltage matches the voltage indicated on the specifications plate of the welding machine.
Connect a plug of adequate capacity for the current consumption I1 indicated on the data plate. Make sure that the
yellow/green conductor of the power cable is connected to the plug's earth contact.
The capacity of the overload cut-out switch or fuses, positioned between the power supply network and the device,
must
be adequate for current I1 consumed by the machine. Check the device's technical data.
CAUTION: If mains power extensions are used, the cable supply cross-section must be appropriately sized. Do not
use extensions longer than 30 m.
Disconnect the device from the power supply before transporting it.
During transport of the device, ensure that all applicable local accident prevention guidelines and regulations are
observed.
Use a fork lift truck to lift the power source; consider the position of the device's centre of gravity when positioning
the lift truck forks.
It is essential to use the device only if connected to a power supply with an earth conductor�
Using the device connected to the mains without an earth conductor or to a socket without a contact for
this conductor constitutes very serious negligence�
The manufacturer declines all responsibility for damage to people or property that may occur�
The user is bound to have the efficiency of the earth conductor of the system and the device in use
periodically checked by a qualified electrician.
When switch F is set to OFF position, the display screen shows the message: Power Off
Wait for this message to disappear from the screen before turning back on.
If the power source is turned on with the Power Off message active, the power-on stage will be unsuccessful.
3301051/B
WARNING
WARNING
WARNING
DANGER
NOTICE
23/24