Marzocchi BOMBER AIR Bedienungsanleitung Seite 6

COMPRESSION ADJUSTMENT
The Low-Speed Compression knob allows for changes in low-speed
compression damping. Turn the knob clockwise to increase compression
damping and counter-clockwise to decrease compression damping. Begin by
setting the compression adjuster to the OPEN setting, fully counter-clockwise.
REBOUND ADJUSTMENT
The rebound adjustment is dependent on the air pressure setting. For example, higher
air pressures require slower rebound settings. Use your air pressure to find your rebound
setting. Turn your rebound knob to the closed position, clockwise until it stops. Then turn it
counter-clockwise to the number of clicks shown in the table below.
Air Pressure (psi)
<100
100-120
120-140
140-160
160-180
180-200
200-220
220-240
240-260
260-280
280-300
ADDITIONAL TUNING OPTIONS
VOLUME SPACERS
Changing volume spacers in the shock is an internal adjustment that allows you to change
the amount of mid stroke and bottom out resistance. If you have set your sag correctly
and are using full travel (bottoming out) too easily, then you could install a larger spacer
to increase bottom out resistance. If you have set your sag correctly and are not using full
travel, then you could install a smaller spacer to decrease bottom out resistance.
Installation procedure and tuning options are available online at: marzocchi.com.
Rebound
Starting Rebound Setting
10
10
9
8
7
6
5
4
3
2
1
6
LOW-SPEED COMPRESSION
ADJUSTER
REBOUND ADJUSTER