Possible Cause - Scheppach HCE2600 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

15. Troubleshooting
Fault
Device does not work
The motor starts but there is no build up
of pressure
Irregular operating pressure

Possible cause

No electrical voltage at the device.
Cross section of the extension cable not large
enough and/or the extension cable is too long.
The mains voltage is lower than that specified.
The pump is frozen.
Air intake in the water inlet.
Discharge nozzle is too large.
Air intake in the water inlet.
Remedy
Check the fuse, power cable and power plug
and have them replaced by qualified personnel
if necessary.
Use extension cables with larger cross sections
and/or use shorter extension cables.
Contact the power supply company if neces-
sary.
Check and thaw if necessary.
Check the supply hose and hose connection
and replace if necessary.
Check and replace if necessary.
Check the supply hose and hose connection
and replace if necessary.
GB/IE/NI 19