Hendi 281376 Bedienungsanleitung Seite 7

Idle Mode
During idle mode, the screen is blank and there will
be no oven activity. Opening and then closing the
oven door will activate the ready mode. The oven
Ready Mode
Opening and closing the door while the oven is in
Idle Mode will put the oven into Ready Mode. In this
mode, the oven is ready to either begin a manual or
Door Open Mode
Door open mode is activated by opening the door.
During this mode, the screen is blank. And the fan
and oven lamp work. When the oven was working
Manual Entry
Make sure the microwave is under "READY" mode.
Select the time with the '
show "00:00", select the requested time with the
number keyboard. After that, select the power lev-
el. Press ' ' first and then select the power level
with the number keyboard as shown in below table
(Defrost /10%/20%/30%/40%/50%/60%/70%/80%/9
0%/100%), The display will show the selected pow-
Pause Mode
This mode allows users to pause the cycle to in-
spect or stir the food. While the microwave is oper-
ating open the door or press the 'pause' button to
pause the cycle. The display will show the remain-
Run program mode
This microwave comes with preset programs.
When the microwave is in 'ready mode' press one
of the number keys and the microwave will run the
program. Below you'll find the preset programs.
Button 1
Display (Time) 0:10
Power 100%
Programming
This microwave can preset up to 100 programs. See
and follow "User options - 9 Double digit" session
for setting program no. from 10 to 99 . Open the door
and press and hold "1" on the number keyboard for
about 4 ~ 6 seconds, the buzzer will sound and the
display will show 'PROGRAM' to indicate you en-
' button, the display will
2 3 4
0:20 0:30 0:45
100% 100% 100%
will enter idle mode after a minute of no use, The
time it takes to activate idle mode can be changed
with the 'user options' (Option 4, Timeout Window).
preset cooking cycle. During Ready Mode, "READY"
displays. From the Ready Mode, the oven can go to
almost all of the other modes.
when the door was opened the program will be
paused.
er. If you press again the same power level button,
the power will be back to set 100% power. Also, if
no power level button is set, the power will be de-
fault to 100%. When everything is set press the '
' button, now the microwave will start operating. At
the end of the cycle the display will show 'DONE' or
beeps will be heard until the microwave is opened
or the 'pause' button is pressed.
ing time. To resume the cycle, close the door and
press the 'start' button. When nothing is done the
microwave will go into idle mode.
When operating the microwave shows the remain-
ing time in the display, when it's a multi-stage pro-
gram the total remaining time will be displayed.
5 6 7
1:00 1:30 2:00
100% 100% 100%
tered program mode. Select the time with the '
button, the display will show "00:00", select the re-
quested time with the number keyboard. After that,
select the power level. Press '
lect the power level with the number keyboard as
shown in below table (Defrost/10%/20%/30%/40%/
8 9 0
2:30 3:00 3:30
100% 100% 100%
' first and then se-
EN
'
7