Sure Petcare DualScan Schnellstartanleitung Seite 7

3
x
4
Once the hole is cut, check if there is any metal in the door. If you can see metal, go to
surepetcare.com/pdf and follow the instructions for fitting in a metal door.
5
6
7
15 to 30mm
8
9
10
Remove the external frame. Drill pilot holes in the corners of the
outline to make it easier to cut the hole. Make sure these holes are
touching the line and that they are big enough for the jigsaw
blade to fit through.
Using the jigsaw, cut around the outer edge of the line you have
marked. If the hole is too small, please take the time to carefully file
the hole until the Cat Flap fits through easily.
Now check that the Cat Flap fits through the hole. Remember the
SureFlap logo must be inside the house.
On the outside of the house, make sure the tunnel is securely
pushed through the hole and slide the external frame over it. Using
a sharp pencil mark through the two holes.
Remove the Cat Flap from the door then drill the two screw holes
using a 6mm (1/4'') drill bit. Remember to hold the drill horizontally.
To choose the correct length of screw from the sets provided,
compare the screw lengths to the thickness of your door. The screw
needs to be between 15 to 30mm (19/32 to 1 3/16'') longer than the
depth of your door.
Put the Cat Flap back through the hole, position it centrally and
replace the external frame. Using a cross head screwdriver and
the screws you selected, attach the external frame and fasten the
screws. Once the screws are secure, tighten them.
Lastly, insert the two screw caps with the groove facing away from
the tunnel.
EN
4