Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
jtX`X`h†l|TWYZ\Wi†luU”GGwˆŽŒG_GGt–•‹ˆ SGqˆ•œˆ™ GY_SGYWW_GGXXa\\Ght
Error Codes
EN
Erroe Items
Code
Error Beep
Power
E1
One long beep
frequency Error
for 2 sec
(50/60Hz)
Thermistor
E21
One long beep
Open Error
for 2 sec
Thermistor
E22
One long beep
Short Error
for 2 sec
Temperature of
E3
One long beep
exhaust air too
for 2 sec
High Error
HVT-I Power
E41
One long beep
Error
for 2 sec
HVT-II Power
E42
One long beep
Error
for 2 sec
Cause
Power frequency is other than 50 Hz.
Unplug the power cord plug and check if the power frequency is 50 Hz.
Plug the power cord in 50 Hz power source and see If "E1" appears. If the error
code is displayed again even after the correct power source is provided, contact
the nearest service centre.
Thermistor Sensor which is supposed to
Unplug the power cord and wait for more than 10 seconds. Plug the power cord
sense the temperature of the cavity
again. If the symptom persists, contact the nearest service centre.
inside does not work properly.
(Thermistor Sensor open)
Thermistor Sensor which is supposed to
Unplug the power cord and wait for more than 10 seconds. Plug the power cord
sense the temperature of the cavity
again. If the symptom persists, contact the nearest service centre.
inside does not work properly.
(Thermistor Sensor short)
The oven cavity gets too hot due to
Open the oven door and check if 1) the oven has been operating with no load or
excessive operation with no load or small
too small load, 2) the air filter is placed in a wrong position, or 3) any blocking
load, or due to some blocking materials
materials exist around the Air Exhaust. Cool down the oven (for approx. 30 min)
around the Air Filter or Air Exhaust at the
under the normal temperature. The oven is back to normal when the error code
back of the oven.
"E3" disappears and "ON" appears again in the display window.
Unplug the power cord, remove the blocking materials around the ventilation
openings, cool down the oven (for approx. 30 min) sufficiently, plug the power
cord in again and check if the error code appears again.
If the symptom persists even when the oven is cooled down sufficiently, contact
the nearest service centre.
The circuitry inside the oven is not
Unplug the power cord and wait for 10 seconds.
working correctly.
Plug the power cord in again and check if the error code "E41" appears again. If
the symptom persists, contact the nearest service centre.
The circuitry inside the oven is not
Unplug the power cord and wait for 10 seconds.
working correctly.
Plug the power cord in again and check if the error code "E42" appears again. If
the symptom persists, contact the nearest service centre.
8
Remedy
Werbung
Inhaltsverzeichnis
