Simons Voss Technologies SmartLocker AX Kurzanleitung Seite 40

3. Initial operation
40 / 124
20. For wooden doors: Straighten the motor block and
firmly tighten the fastening pieces with suitable
screws.
20
21. Tighten the nut with 1 Nm (2.5 mm hex wrench).
21
22. Insert the clamping element and the plastic coun-
tersunk screw into the D-hole bushing from the
front.
22
23. Screw the tensioner until it stops (TX10 key)
without screwing through the screw.
23
24. Place the reader at an angle (approx. 60°).
24
25. Turn the reader clockwise straight (bayonet
mount).
25
26. Route the cable past next to the area of the light
guide.
27. Insert the plug into the socket with the lug facing
the circuit board using the special tool.
26
The reader beeps and flashes three times.
9
28. Attach the light guide and press it firmly.
27
Reader protected against twisting.
9
29. Store the excess cable in the gap next to the PCB.
30.Hook the lid on top.
28
SmartLocker AX
EN