Faults And Error Messages; Error Messages; Maintenance; Storage And Transport Conditions - ADE M322600 Gebrauchsanweisung

8.4

Faults and error messages

8.4.1 Faults
Fault
The display shows
nothing.
The display shows
nothing.
The display shows
nothing.
The display shows
nothing.
The display shows
nothing.
The display indication
shows cryptic characters.
The scale wobbles.

8.4.2 Error messages

Error message
[Lo]
[uLoad]
[oLoad]
[no 0.00]
8.5

Maintenance

To ensure correct measurement, maintenance and repair should only be carried out
by authorised personnel.
To prevent the intended level of accuracy the product must be set up carefully and services
regularly. We recommend having it serviced every 3 to 5 years depending on how often the scales
are used.
8.6

Storage and Transport Conditions

Keep all original packaging materials and components for eventual return of the scale to avoid
damage during transport; these are not covered by the warranty.
Disconnect all cables before transport and use the mains switch on the back of the scale to switch
it off to avoid damage.
M322600-210429-Rev004-UM-en
Cause
The scale has switched off
automatically.
The main switch is not switched
on.
Not connected to the mains.
The battery is empty.
No battery is inserted.
The display is in "Turning mode".
The scale is not levelled properly.
Description
Empty battery.
Underload (-20d)
Overload (-9d)
No zero point available.
Measure
"Tap" or switch on the scale.
Switch on the main switch.
Use the optional mains adapter to
connect the scale to the mains.
Insert new batteries.
Insert batteries.
Press the Turning key.
Adjust the support feet. Use the
spirit level to check the horizontal
position.
Troubleshooting
Insert new batteries.
Use the scale in mains operation.
Switch the scale off and on again.
Unload the scale. Zero range or
weighing capacity exceeded
Zero the scale.
Page 29 of 108