Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Changing Gears
1st gear
0 - 550 rpm
2nd gear
0 – 1250 rpm
3rd gear
0 – 2700 rpm
Warning!
!
Never apply force, and change the gear only when the tool
is running down.
Never use tools, such as hammers or pliers to change the
gear.
Manual Drilling
wet drilling
dry drilling
Rig drilling
wet drilling
Manual Drilling
Dry drilling
Mount the appropriate adapter for dedusting.
(refer to illustration at p. 21)
Fix the required dry drill bit on the working spindle.
Check for appropriate gear selection. Operate the ON/OFF switch and drill
until the segments are approximately 5 mm in the material. Remove the
The ETN 152/3 P is equipped with a 3-gear oil-
bath gearing. Select the speed according to
the drilling diameter.
Use the gear selector to change to next higher
or lower gear.
If gear changing is too heavy, slightly turn the
working spindle to ease gear changing.
Switching the tool on and off for a moment
may also help to ease gear selection.
Diameter (mm)
42 – 72
12 – 32
122 - 200
62 - 112
12 - 62
82 - 152
42 – 72
12 – 32
Insert the centering point so that the recesses
in the centering point latch on the catches of
the working spindle.
23
Gear
2
3
1
2
3
1
2
3
Werbung
