Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
EN
Coolant Supply F F o o r r m m A A D D / / J J D D
R R E E S S U U L L T T
Coolant supply is changed over to F F o o r r m m A A D D / / J J D D .
62
62
Heat the threaded pins or the threaded pin area until the threaded pins
can be unscrewed.
W W A A R R N N I I N N G G
R R i i s s k k o o f f b b u u r r n n s s f f r r o o m m h h o o t t t t h h r r e e a a d d e e d d p p i i n n a a r r e e a a ! !
After heating, wait until the heated threaded pin area has cooled
down.
Unscrew the threaded pins using an hex-wrench 2.5.
Remove the adhesive residues from the threaded pins and threaded bores.
Screw the threaded pins with medium-strength thread locking compound
(adhesive) into the cooled tool holder at "Pos. 1" (see
Supply F F o o r r m m A A D D / / J J D D
).
Remove any adhesive residues.
After the curing time of the adhesive, check the threaded pins for secure
fitting and rebalance the tool holder, if necessary.
Use a pull stud with coolant bore for the machine-side sealing of the tool
holder.
Fig. 16: Coolant
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions
Werbung
