Mapal HTC Montage- Und Betriebsanleitung Seite 54

N N O O T T I I C C E E
D D a a m m a a g g e e c c a a u u s s e e d d b b y y t t o o o o l l l l e e n n g g t t h h a a d d j j u u s s t t m m e e n n t t w w i i t t h h c c l l a a m m p p e e d d t t o o o o l l ! !
EN
 Do not change the tool length adjustment as long as the tool is clamped.
EN
Adjusting tool length (radial)
54
54
I I N N F F O O R R M M A A T T I I O O N N
The stop screw for radial tool length adjustment is not secured to
prevent it from falling out. The specified adjusting range cannot be
exceeded.
Adjust the HTC clamping chuck to the tool length by turning the screw
for radial tool length adjustment using an appropriate hex-wrench with
T-handle.
I I N N F F O O R R M M A A T T I I O O N N
The tool length is adjusted by means of a bevel gear unit. Adjust-
ment is performed in several steps:
• Adjust the unclamped tool shank to 0 0 . . 2 2 t t o o 0 0 . . 3 3 m m m m below the
target length.
• Clamp the tool shank up to the gripping point.
• Adjust the desired tool length.
The tool shank has to be released again if the tool has to be adjust-
ed again.
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions