Mapal HTC Montage- Und Betriebsanleitung Seite 51

Inserting tool
I I N N F F O O R R M M A A T T I I O O N N
Depending on the design of the hydraulic chuck, tool length adjustment can be performed either axially (see
section 5.1.1
5 5 . . 1 1 . . 1 1 A A x x i i a a l l t t o o o o l l l l e e n n g g t t h h a a d d j j u u s s t t m m e e n n t t
N N O O T T I I C C E E
D D a a m m a a g g e e f f r r o o m m f f a a i i l l u u r r e e t t o o o o b b s s e e r r v v e e t t h h e e m m i i n n i i m m u u m m c c l l a a m m p p i i n n g g d d e e p p t t h h i i n n t t h h e e H H T T C C c c l l a a m m p p i i n n g g c c h h u u c c k k ! !
 Observe the prescribed values for the minimum clamping depth (see
data [inch]
).
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions
Push the tool, shank first, to the stop screw in the location bore in the
HTC clamping chuck.
section 5.1.2
) or radially (see ).
Tab. 2: Technical data [mm]
EN
EN
Tab. 3: Technical
or
51
51